Edit clips in a Mix
Replace footage, adjust start times and duration, and reorder clips to put favorite moments where you want them. Select a Clip in the Video track to begin.
Open the Mix and select a clip. Moving clips or adjusting their shared cut requires at least two Clips in one Part. Insert another if needed.
01 Select a Clip
A Part has its own pace settings; a Clip is one video segment within it. Click Video to select a Clip, or Parts to select the whole Part.
- Check that Selected shows the intended Part and Clip numbers.
- In mix is the clip's position in the arrangement. Source range is the interval used from the original video.
- Expand Timing follows Part to view the average playback rate. The clip follows its Part's rhythm rather than having an independent speed setting.
02 Change a clip's playback duration
To hold a shot two seconds longer, change its Duration. The panel shows the effect on the clip, Part, and entire Mix.
- Enter a playback duration between 10 seconds and 10 minutes. Use minutes and seconds, arrow keys for small changes, or Shift for larger steps.
- Review the proposed Clip, Part, and Mix durations before applying.
- Click Apply duration to commit, or Cancel to discard.
- Check later clips and total duration. Use Undo to restore the previous arrangement.
Changing clip duration shifts later content. If footage is insufficient, shorten the request or change Part conditions. Apply checks the source range again: if only 10.5 seconds are available for a 12-second request, keep the original and shorten the request or choose another interval. If Discard unapplied Clip changes appears when switching objects, choose Keep editing or Discard changes.
03 Replace footage without changing duration
Use replacement when the timing works but you want different footage.
- Select a Clip and click Replace video… beside Source video.
- Choose a candidate and inspect its preview.
- Click Replace video to confirm, or Cancel.
- Recheck Source video, Source range, and the Positions track.
Replacement keeps playback duration but may change the pose. No matching videos means no candidate meets the current conditions; shorten the Clip or adjust Part settings.
04 Choose another moment in the same video
To start at another action in the same video, move the source range.
- Click Edit source range…, or select a Clip and press Shift+T.
- Drag the selection's center to move the interval or its ends to resize it. Source start, Source end, and Playback duration offer precise controls.
- Use Preview selection to check the motion and length.
- Apply changes commits the range; Cancel discards the draft.
Moving the interval and resizing it are different operations. Resizing may affect Part and Mix duration; review the impact first.
05 Insert and reorder clips
- Select a Clip and choose Insert clip → Before or After.
- Set the duration, choose a candidate, and adjust its source range if needed. Confirm the insert.
- If the video is outside the Mix's sources, resolve the source prompt before confirming.
- Use Move clip to move a selected clip earlier or later, or drag it within the same Part. Release at a valid insertion marker.
Inserting adds time; moving changes order. If no valid insertion marker appears, cancel and try another position. Moving a Clip differs from adjusting the cut between two Clips.
06 Adjust a cut or delete a clip
Moving the cut between two 12-second clips by one second gives 13 and 11 seconds, still totaling 24.
- Drag the boundary between adjacent Clips to redistribute their durations.
- Delete clip removes a selected clip and shifts later content earlier.
- Delete clip and part means this is the Part's only clip; deleting it also removes the Part.
- Check Part count and total duration afterward. Use Undo / Redo as needed.
Check the shortcut help for Delete / Backspace. It describes deleting the selected Clip, not directly deleting a Part. For a Part's last clip, read the button label and warning carefully.