Adjust playback range and intensity

Set the range, intensity, and direction you prefer, then save them to a device profile. With the device connected, the output preview shows the result. These settings leave the original script unchanged.

Before you start

Open a video with a linked script, click Play with script, and select a device profile. This example uses Practice output; select your own profile when following along.

Need a device profile? Start with Add a device profile, then return here to adjust its output.

01 Adjust output by axis

Click Device output settings to open the device controls. Check the selected profile, then expand L0 Stroke or another axis. These controls change playback output, not the saved script nodes. Other videos played with this profile use the same output settings.

ControlWhat it doesWhat to check
OutputTurn output for this axis on or off.Turning off L0 leaves its curve intact and does not turn off other axes.
Range / Minimum / MaximumSet the output position range. The minimum cannot exceed the maximum.For example, 20–80%. The device's physical limits may restrict the available range further.
IntensityReduce movement around the center of the selected range.With Range at 20–80 and Intensity at 50%, a full 0–100 source curve maps to 35–65.
InvertReverse the axis's direction during playback.This leaves the saved node positions unchanged.
Reset axisReset this motion axis to enabled, range 0–100, intensity 100%, and no inversion.Click Apply to save the reset. Other axes and the video sync offset are unaffected.
Function channels / Output ceilingSet an output ceiling for function channels such as V0, A0, A1, and A2.Output requires both a source track and device support for that channel. Setting a ceiling does not create a missing track.
Apply / DiscardSave the profile changes or discard unsaved edits.After Apply, check the profile name next to Saved for. Unsaved changes have not been saved.
  1. Pause playback and check the selected profile and L0 axis.
  2. Set Minimum to 20, Maximum to 80, and Intensity to 50, then turn on Invert.
  3. Click Apply and check the profile name next to Saved for. This screenshot uses Practice output; your screen will show your selected profile.
  4. Connect the device and play a short section. The timeline shows the output preview beside the source curve. Here, source position 53 maps to about 49. Other axes are unchanged.
  5. To restore the defaults, use Reset axis and Apply. To abandon changes you have not applied, use Discard.
Applied settings are saved to the profile. The cyan output preview appears on the timeline once the device is connected.
L0 set to range 20–80, intensity 50%, and inverted, saved to Practice output
This example has no V0 track, so it shows the setting only. The draft was then discarded.
V0 output ceiling draft at 60%, with No track in current source

This example uses an offline profile, so no device is connected and the timeline shows only the source curve. No track in current source means the current video has no matching track; Capabilities not verified means the device's capabilities have not been confirmed. Connect the device to see the output preview and check actual output.

Check playback after saving

  1. Confirm that Saved for shows the correct profile.
  2. Reopen the profile and check Range, Intensity, and Invert.
  3. To send movement to a device, connect it and confirm Device output is enabled. An offline preview does not indicate a device connection.

To adjust overall timing, return to Calibrate / Offset. To change saved node positions, use the editor's range tools.