Adjust motion range and direction

Change the range and direction of a selection without moving its timing. Stretch the range, cap peaks and valleys, scale the motion, or invert the curve.

Before you start

In Library, select a video with a script. Open Details, click Edit in the Script section, and check the active axis. These examples use Sofia's 15-second script. You can use your own video; node counts and values will differ.

01 Normalize vs. Clamp

The 25 selected nodes include positions 16, 22, 50, 78, and 84. Their current range is 16–84. We'll give both tools the same target range, 35–65, and compare the results.

  1. In Select by time, enter From 0 ms and To 9000 ms. Choose Replace, then Select range. This selects 25 nodes spanning 0–8675 ms in the example. Check the selection, then open Normalize.
  2. Set Minimum to 35 and Maximum to 65. Check Amplitude 68 → 30 and the curve preview.
  3. Click Apply Normalize, inspect the result, then use Undo to restore the original curve.
  4. Select the same time range again, open Clamp, and set the range to 35–65 again.
  5. Check which nodes hit the limits, then click Apply Clamp. Use Undo again if you want to restore the original.
Original positionNormalized to 35–65Clamped to 35–65
163535
22About 3835
505050
78About 6265
846565

Normalize maps the original range proportionally to the new range, preserving the relative differences between nodes. Clamp caps positions outside the limits and leaves positions inside them unchanged. Multiple peaks may end up at the same boundary.

After Normalize, the relative differences between peaks and valleys remain. Selected time and Position show the actual selection.
After Normalize, 25 selected nodes are proportionally mapped to 35–65
After Clamp, peaks and valleys outside the limits line up at the boundaries. Nodes inside the range retain their original values.
After Clamp, out-of-range nodes sit at 35 or 65; nodes within the range stay unchanged
Preview the Normalize settings
Minimum and Maximum set the target limits. Apply Normalize commits the change; Cancel Normalize discards it.
Normalize preview with Minimum 35 and Maximum 65

With no selection, Normalize and Clamp affect the entire script. Both require at least two nodes; Normalize also requires at least two different positions. Check the scope before adjusting the settings.

02 Scale a range or reverse its direction

Use Select by time to choose the nodes. This example selects 11 nodes from 50–3800 ms, with positions from 22–78. You can choose a different interval.

Scale lets you drag the boundaries of selected nodes. Select at least two nodes with different positions, click Scale, and drag the Lower or Upper handle. You can also focus a handle and use the arrow keys. When the preview looks right, click Apply Scale. To cancel, use Cancel Scale or Esc.

Scale changes the position range of selected nodes, not their duration on the timeline.
Scale range handles with Apply Scale and Cancel Scale

Invert uses 100 − position to reverse positions: 22 becomes 78, 78 becomes 22, and 50 stays 50. Node times stay unchanged. Finish or cancel the Scale preview, select the nodes, and click Invert. After Saved appears, you can compare the result with the original in History.

Check the result
Changing the motion range should leave node times unchanged. To shift motion earlier or later, use Phase Shift.

Check your changes

Check that positions changed while node times stayed the same. Play the selection after applying.